Metal Liner High Chrome Slurry Pump With Discharge 4 Inch / Suction 6 Inch

Metal Liner Sand Pump Slag Removal Pump With Discharge 4 Inch And Suction 6 Inch

Main introduction of slurry pump

slurry pump 6 / 4 E- bearing assembly: The bearing assembly of the pump adopts a cylindrical structure, which is convenient for adjusting the clearance between the impeller and the front guard plate. The bearing can be completely removed during maintenance and grease lubrication.
Shaft seal (sealing): The shaft seal type of the pump has packing seal, impeller seal and mechanical seal.
Transmission mode: V-type V-belt drive, flexible coupling drive, gear reducer drive, hydraulic coupling drive, variable frequency drive, thyristor speed control, etc.

Model meaning 

6 / 4 E -

6-------Suction diameter

4-------Discharge diameter

E-------Support type

------ Slurry pump type

Specifications

Typical Applications:

Ash Handling

Cyclone Feeds

Pulp and Paper

Abrasive Slurries

Coal Preparation

Mineral Processing

Aggregate Processing

Construction Design

Material

Alloy A05 is a wear resistant white iron that offers excellent performance under erosive conditions. The alloy can be effectively used in a wide range of slurry types. The high wear resistance of alloy A05 is provided by the presence of hard carbides within its microstructure. Alloy A05 is particularly suited to applications where mild corrosion resistance, as well as erosion resistance is required.

A07 Is Martensitic white iron with moderate erosion resistance.

Alloy A49 is a corrosion resistant white iron suitable for low pH corrosion duties, where erosive wear is also a problem. The alloy is particularly suitable for Flu Gas Desulphurisation (FGD) and other corrosive applications, where the pH is less than 4. The alloy can also be used in other mildly acidic environments. A49 has an erosion resistance similar to that of Ni-Hard 1.

Performance table