300mm DT - A60 Single Suction Horizontal Desulfurization Pump For Absorption Tower Industial

300mm DT - A60 Single Suction Horizontal Desulfurization Pump For Absorption Tower Industial

Based on the successful design experience in manufacturing ZJ series slurry pumps and absorbed home and abroad advanced technology, we designs and manufactures DT and LT type pump, a special FGD engineering pump.

The max flow range can be up to 12000m³/h, the head is generally less than 100m. This type pump apply to all the desulfurization system, which can be used as a slurry circulating pump in large absorption tower and limestone slurry pump, gypsum slurry discharge pump, recycling pump, sump pump and so on.

The desulfurization pump is an important equipment in the desulfurization equipment industry. It is of great help to reduce the emission of sulfur dioxide. The desulfurization pump suction cover has been widely developed and applied. The use of desulfurization pumps has a lot of attention. Sealing performance is the key. If the seal is not good, it will leak, affecting the use effect and causing environmental pollution.

The mechanical seal of the desulfurization pump must meet the requirements of the medium, easy to use, desulfurization pump accessories, good sealing performance and long service life. Therefore, it is necessary to improve the sealing technology and anti-vibration capability of the desulfurization pump, and improve the operating efficiency and impact resistance. Environmental pollution is an important issue in today's society, and it is also the focus of people's attention. There is a lot of room for development of these equipment to reduce pollution emissions.

Performance and material characteristics

1. High efficiency, long service life and reliable operation.
2. The wet parts are made of low carbon stainless steel material.
3. Low carbon stainless steel mainly consisting of ferritic has excellent resistance to chloride stress corrosion cracking and higher mechanical strength.
4. Less hydraulic friction, the efficiency is higher than the same parameters of the metal pump about 3%.
5. Metal pump is easy to control the geometric dimension and high volume efficiency. The pump parts is with high surface and small clearance. The overall efficiency of 5% higher than non-metal pump.
6. The wet parts has long-service life and long-term shear wear ability. Shear sliding wear ability of metal protective plate is stronger than that of the common non-metallic materials.
7. Dynamic abrasion resistance is 0.008-0.08mm every year, with high tensile strength. The pump performance can be maintained constant in the long-term abrasion conditions

Specification

Construction Drawing