WN Series Closed Impeller Abrasion Resistant Sand Dredge Pump For River Dredging

WN Series Closed Impeller Abrasion Resistant Sand Dredge Pump For River Dredging,450WN,200WN,500WN,650WN

Product Introduction of dredge pump

WN (Q) dredging pump is a kind of highly effective wear-resistant marine dredging pump, which is based

on absorption of abroad technology. WN (Q) dredging pump meets the comprehensive dredging

requirement at home and abroad.

Features

Overall structure performance well in marine use

1. Simple and reliable structure: 200WN-500WN and 600WNQ-1000WNQ type dredge pump with a single

    pump casing or double pump casing, single stage single suction cantilever horizontal structure.

2. According to the connection type with the gear box, there are two kinds of typical structure, one is with

    independent support, the other is combined with gear box. The lubrication of pump with support is  

    grease lubrication or thin oil lubrication.

3. The double casing design can make the pump body safe even when the liner is worn out.

    Easy to disassemble and maintenance: WN type dredging pump can be disassembled from front. This

    make the disassemble and maintenance easier.

Good performance of dredging

1. Good cavitation performance: WN type dredging pump have good cavitation performance which can

     ensure suction ability of pump. While it can achieve greater digging depth and higher suction

     concentration.

2.  High flow capacity and wide applicability: WN type dredge pump impeller passage is very wide to

     continuous pumping gravel or high plastic clay and not happens jam. Good carrying ability of pump

    is guarantee for dredger performance.

3. Sharp Dropping performance curve: The flow and head curve falling steeply makes the mud pump

    having a stronger adaptability to the change of row spacing.

4.  Achieving various blendings of pump performance: WN dredging pump can change the rotational

     speed and the diameter of the impeller, to achieve the different head of pump under the same flow.

Wear-resistant and long-life service wet parts

1. Wet parts of WN dredging pump , such as impeller, volute liner, throat bushing and frame plate liner

    insert(wearable liner) adopt alloy cast iron material whose hardness is not less than 58HRC.

2. It has not only impact on resistance but also high anti-abrasion performance.

    The service life of each part is fully considered in the process of product design. The same  

      replacement cycle reduces the maintenance and replacement costs.

3. Small hydraulic loss, high efficiency, low power consumption: Due to the advanced hydraulic model,

    the dredging pump has high efficiency level. The efficiency of WN dredging pump is higher about 2-3

    percentage points than imported. Thus, in the same production, it can achieve lower fuel consumption.

A reliable seal and no leakage

1. 200WN-500WN dredge pump adopts mechanical seals or packing seals or combination of mechanical  

   and packing seals.

2. 600WN(Q)-1000WN(Q) dredge pump adopts shaft seal with L-shaped screw shell rubber seal device

    which has three L-shaped seal rings and one shaft sleeve with special thread.

Specifications quick check

Performance table